M2EXV
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax:
+81(6)6659-8510 E-mail: [email protected]
EM-5133-A Rev.1 P. 3 / 4
EXTERNAL VIEWS
Display
Mode Button
Set Button
Configurator Jack
Up Button
Down Button
Up
Down
Mode
Set
Output Setting DIP SW
ON
1
2
3
4
5
6
7
8
SW1
OFF
ON
1
2
3
4
5
6
7
8
SW1
OFF
PERCENT
100.00
OUTPUT
20.000
%
mA
COMPONENT
FUNCTION
Display
Indicates present values, setting values and abnormal information.
Two types of present values at
upper and lower are displayed by setting.
Mode button
Used to shift from measuring mode to each setting mode.
Destination to shift is changed by the time
pressing and holding the button.
Used to return from each setting mode to measuring mode. (press
and hold for 2 sec. or more)
Set button
Used to change setting value of setting parameter.
When at setting changeable state, used to enter
(save) the setting value.
Used to move on through digits of setting value for input/output scaling at
setting changeable state,
Up button
Used to shift through setting parameter, and to increase or select setting value.
Down button
Used to shift through setting parameter, and to decrease or select setting value.
Configurator Jack
Used to configure with M2E configurator software (model: M2ECFG). At the same time, set the lock-
out setting of the unit to ‘lock’.
DIP SWITCH
The internal DIP switch for output setting is required to
select output types before setting a precise output range us-
ing front buttons or setting with a PC.
Refer to the operating manual (EM-5133-B) for the opera-
tion with front buttons. Refer to the users manual (EM-
5147) of M2E Configurator Software (model: M2ECFG) for
setting with PC.
Output Type
SW1
1
2
3
4
5
6
7
8
0 – 20mA
OFF ON OFF OFF OFF OFF ON OFF
−5 – +5V
OFF OFF ON OFF ON OFF OFF ON
−10 – +10V OFF OFF ON OFF OFF ON OFF ON
CAUTION:
DO NOT set DIP switches while power is
supplied. Otherwise, the unit may fail.
WIRING INSTRUCTIONS
■
SCREW TERMINAL
Torque:
0.8 N·m
■
SOLDERLESS TERMINAL
Refer to the drawing below for recommended ring tongue
terminal size. Spade tongue type is also applicable.
Applicable wire size: 0.25 to 1.65 mm
2
(AWG 22 to 16)
Recommended manufacturer: Japan Solderless Terminal
MFG.Co.Ltd, Nichifu Co.,ltd
6 (.24) max
3.3 (.13) max
mm (inch)
