GR8-EM
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-8621 Rev.5 P. 4 / 15
INSTALLATION
■
COUPLED WITH DL8
The unit coupled with DL8 is used by connecting to DL8 and R8 series I/O modules. First, mount all the DL8 and I/O modules
with the power OFF. Connect the unit in the same manner to DL8 and I/O modules. Attach the protective cover of DL8 to
GR8-EM.
Note: Make sure to install the unit at the end of all the other modules. With the unit installed between DL8 and I/O modules, I/O
modules after the unit can not perform internal communication or the power can not be supplied to these I/O modules.
Confirm that the locking clamps of the unit are set. Insert the unit straight in perpendicularly to the rail such that the
grooves of the unit and the module on the immediate left engage each other. (A & B in the below figure)
A
B
• HOW TO INSTALL
Confirm that the locking clamps of the unit are set. Insert the unit straight in perpendicularly to the rail such that the grooves of the
unit and the module on the immediate left engage each other. (A & B in the below figure)
• HOW TO ATTACH PROTECTIVE COVER
Align the hooks on the cover with the grooves of the unit and slide the cover straight until the hooks are latched.
groove
hook
When removing the cover by DIP SW setting, pull it out while squeezing the hooks inward.
