M-neb Dose+, Instructions For Use Manual

Page: 29 / 40

- 29 -
WARNING
Do not open the housing. All repairs or maintenance may only be done by a dealer
qualified by NEBU-TEC med. Produkte Eike Kern GmbH.
Failure to observe this leads to the loss of the warranty claim.
11.0 Diode displays
Symbol Diode Meaning
Battery status
indicator
The battery status indicator [LED red/green] is
controlled so that:
-
the green LED lights up when the capacity of the
battery is over 30%.
-
the green LED lights up alternately with the red LED
(exchange rate 1 second: 1 second) if the capacity of
the battery is greater than 10% and less than 30%.
-
the red LED stays lit when the capacity of the battery
is less than 10%.
-
the green LED blinks in intervals (1 second: 1 second)
when charging is enabled.
-
the green LED blinks in intervals (1/10 s lit: 1 s not lit)
when charging is completed.
Operating mode
status indicator
The operating mode status indicator [LED blue] lights:
-
blue three times briefly when the boot phase is
terminated.
-
blue once briefly when the FLOW recording is
activated.
-
continuously blue if the RF power amplifier is enabled
(power indicator).
12.0 Ambient conditions
The environmental conditions of the M-neb
®
dose
+
mesh nebulizer MN-300/8 are listed in
the following chapters which are required for the proper functioning in accordance with the
intended use of this device.
12.1 Operating conditions
Operating the device is guaranteed under the following environmental conditions:
Ambient temperature: +10°C to +40°C,
Relative humidity: 25 % to 75 %
Air pressure: 450 hPa to 1100 hPa
12.2 Transport and storage conditions
The transport and storage of the device is ensured under the following environment
conditions:
Ambient temperature: -10° C to +50° C
Relative humidity: 25 % to 75 %
Air pressure: 450 hPa to 1100 hPa