GB
VDV-B90 | ENGLISH
10
10
INTRODUCTION
VIDEO INTERCOM MODULE VDV-B90
AUDIO INTERCOM MODULE ADV-B40
Thank you for purchasing an m-e product. This add-on module allows
you to equip existing intercoms, which are fitted inside e.g. letter box
systems or pillars, with the VISTADOOR system or convert them to this.
Internal units of the VISTADOOR and VISTUS systems can be connected.
It is suitable for connecting up to six parties.
CONTENTS
Tech box
Loudspeaker module c/w 50 cm long connector cable
Microphone module c/w 50 cm long connector cable
Camera module c/w 50 cm long connector cable (only VDV B90)
Adhesive pads for securing in position
Light sensor c/w 50 cm long connector cable
Available as optional accessories
External camera mod. VDV 500 Xcam, Xcam Pro1, Xcam Pro2, Xcam Pro3
Cap rail power supply unit mod. DT 2000
Mains adapter mod. ST 1000
Requirements
A simple make contact for each apartment is all that is needed in terms
of bell push. If a loudspeaker and microphone are present, these must
meet the following specifications if they are to work properly with the
add-on module:
Loudspeaker
Impedance: 8 ohms
Power: minimum of 0.5 watts
Microphone
Electret microphone
Phantom power: 5 volts (ensure correct polarity)
If the technical data are not known, to prevent any problems with
voice transmission, you should replace the existing loudspeaker and
microphone with the loudspeaker and microphone supplied.
KEY
1. Tech box
1.1. Housing cover
2. Cable entry
3. Terminal (button, microphone, loudspeaker etc.)
4. Terminal (connection for internal units)
5. Terminal for door opener
6. DIP switch user code
7. DIP switch door opener time
8. Terminal for external camera
9. Volume potentiometer
10. Piezoelectric beeper
11. Mounting holes
12. For unlocking housing cover
13. Strain relief (2x)
14. Adhesive pad for microphone module
15. Adhesive pad for camera module (4x)
16. Adhesive pad for loudspeaker module
17. Camera module (only VDV B90)
18. Loudspeaker module
19. Microphone module
20. Power LED
21. CDS sensor
CONNECTION OPTIONS FOR THE TECH BOX
Top connection terminal (26-pole)
LED+ and LED-
: This is for connecting an LED which lights up when
the door opener is operated to indicate to the visitor that the door is
being opened. Output: 5 V DC max. 50 mA
MIC+ and MIC-
: This is for connecting the microphone, the white
cable to + and the black cable to -.
KEY1 to KEY6
(2 screw terminals each): This is for connecting the
relevant bell push. KEY1 activates the internal unit, which is connected
to VIDEO1 and AUDIO1, etc.
9_12Vcc, GND, VIDEO and IR
: This is for connecting the camera
module. Red cable to 9_12Vcc, black cable to GND and yellow cable to
VIDEO. The fourth cable of the camera module is connected to IR.
SPK- and SPK+
: This is for connecting the loudspeaker, the red cable
to + and the black cable to -.
CDS_L- and CDS_L+
: This is for connecting the brightness sensor,
the red cable to + and the black cable to -.
VDV-B90+40_I-Manual_210x240_Fin3.indd 10
09.05.14 11:48
