JS-MD 3 RES
Flight Manual Supplement
MD11-AFM-00-002
Issue: 02
Rev. 00
Rev. Date: 24-Mar-23
Page 4
–3
•
Raise and lower the pylon
•
Activate the DC-DC converter when in Standby mode to charge
selected 12 V battery
Normal Operation Screens
4.3.1
Standby Mode
Standby mode is entered when the system is powered up (RES master
switch turned ON) and the built-in-test procedure has been completed
successfully.
•
Date and time (dd.mm.yyyy)
•
Motor total time (hh:mm)
•
Battery voltages (HV-L / 12 V / HV-
R)
•
State of Charge of left and right HV
batteries
•
Maximum cell temperature in HV
battery
•
Motor temperature
•
Controller temperature
When pushing the EXT/RETR toggle switch upwards once whilst in
standby mode, the following actions are triggered:
1. The motor controller is switched ON and pre-charged
2. HV batteries are switched ON and connected to the power rail
3. The propeller alignment function of the motor controller
becomes active
4. The electromechanical actuator (spindle drive) extends the
pylon (the system will therefore transition out of standby mode
into extended mode as discussed below)
