Installation
For optimal performance of the LX4-2.1, please read the following thoroughly
and carefully prior to installation.
Precautions
Handling:
Please do not touch the speaker cones.The LX4-2.1 set is packaged
in the box tightly, so your attention is required when taking the monitors out of
the box. To avoid possible damage to the speaker units, hold both sides of the
monitor in order to pull it out of the box. The speaker cones should not be
touched in order to avoid damage even after they are out of the box.
Connections:
Connect the TRS balanced/unbalanced inputs of each LX4
subwoofer unit to the corresponding pre-amp, computer or game console
outputs.We recommend that you use high-quality balanced or unbalanced cables
for input connections. Also, turn off the power of the LX4 and turn the volume
of the LX4 down to a minimum before making the necessary connections.
Correct Power Operation:
Since the LX4-2.1/ 5.1 contains amplifiers, it must
be connected to a power outlet using the detachable AC cable provided. Before
connecting power, please make sure that the Voltage-Select Switch located on
the speaker’s rear panel is set to the appropriate position, as described in the
rear-panel features list appearing earlier in this manual.
WARNING! - Use of improper Voltage-Select Switch combinations may
result in hazardous conditions and/or damage to speaker components
not covered by speaker warranty.
TRS Balanced/Unbalanced Connections
Assure that the power switch of the LX4 is turned to off and that the Master
Volume of the LX4 is turned down to a minimum. Connect the male end of a
TRS balanced or TS unbalanced cable to the TRS inputs of the LX4 (refer to the
following diagram for TRS connections).
6
Summary of Contents for LX4-2.1
Page 12: ...Appendix B Block Diagram 12 ...
