7
If your DMX-512 signal control station is a 5-pin XLR socket (head), you must
use a 5-pin to 3-pin from the conversion line, specific conversion method as shown
below:
When the console control signal input to the full color animation laser
performance device, all full color animation laser performance device must first set
address code. In order to Role of the corresponding control signal. So, when using any
controller, each lamp must have its own address code. So, in the first lamp address is
set to 1, second sets of lamps address code is set to 13 (the first lamp address codes 1
and 12 channel),Third table lamps set in position 25. And so on (this setting is
required according to control different set, now only with common people).
The specific DMX-512 signal control mode of address code switch is arranged as
below:
The lights
The starting address
Digital display
（
ON
）
1
1
A0.01
2
13
A0.13
3
25
A0.25
┇
┇
┇
ILDA interface control method using the function mode:
The ILDA interface signal line access standard automatically switch to ILDA
interface control mode.
Note: disconnect the power first, then plug the ILDA interface signal lines, so as
not to damage the lamp.
Master slave synchronization function matters needing attention:
1, as the host, the lamp will send DMX-512 signals, you cannot connect to the
DMX-512 console, otherwise it will interfere with each other, not synchronous
operation.
2, a plurality of lamp master-slave synchronous operation, of which only a
mainframe, the other from the machine. Not synchronous operation.
Master slave synchronization connection diagram as follows: