Description
The RFR 1001 is a mounting bracket for any single yellobrik module.
The bracket can be mounted on any surface using the appropriate
screws to hold it securely in place (screws not supplied). The mounting
holes are positioned on standard 19” rack rail centers, so the bracket
can also be secured in the rear of an equipment rack if needed.
Mounting a module in the bracket
No tools are required to insert and remove a module from the bracket.
Please refer to the diagram (opposite) and follow these instructions to
insert or remove a module.
1
. Loosen the white thumbscrew to allow the clip to move down
2
. Insert one end of the module as shown, locating the bracket tab into
the module slot
3
. Move the module to position the other end above the lose clip and
insert the clip into the module slot. Ensure the two pins locate
correctly to lock the clip in place.
4.
Tighten the thumbscrew
Try to move the module to ensure the fit is secure.
