Lynxspring JENEsysONE JO-PC1, Mounting Manual

Page: 8 / 26

JO-PC1 Base Controller Mounting and Wiring Guide
Updated: January 16, 2012 Part Number JO-PC1 rev 1
About Expansion Options
About Option Cards
8
About Expansion Options
The JO-PC1 controller provides for field-installable expansion with two kinds of options:
•
Option cards —Install on connectors inside the controller base unit. See “About Option Cards” .
•
Accessory modules —To “chain” on the JO-PC1’s 20-pin end connector. See “About Accessory
Modules” .
About Option Cards
The JO-PC1 has two (2) option slots for custom option cards designed for use with JENEsysONE controllers.
Each slot has a 30-pin connector on the controller’s base board. See
Figure 3 on page 7.
Warning
Power to the controller must be OFF when installing or removing option cards, or damage will occur!
Also, you must be very careful to plug an option card into its connector properly (pins aligned).
Option cards typically provide additional communications features, such as with the following available models
(with others still in development) listed in
Table 1 .
For more details on port assignments and other features, refer to specific option card installation documents.
Table 1 JO-PC1 option cards.
Model Description Notes
JENE-PC-LONCARD FTT-10A LON (LonWorks) adapter
with a 2-position removable
screw-terminal connector plug.
Up to 2 LON option cards may be installed.
•
If one LON option, it operates as LON1, regardless of slot.
• If two LON options, LON1 is Option slot 1, LON2 is Option slot 2.
JENE-PC-MODEM 56Kbps Auto-dial/Auto-answer
Modem with one RJ-11 connector
for phone line.
Note: Not supported if
JENE-PC-GPRS modem option is
also installed.
Maximum of one. Does not have own UART. Must be installed in
Option slot 1, where it operates as COM1. This disables the RS-232
base serial port (DB-9 connector) on the JO-PC1 during normal
operation.
Note:
If a JENE-PC-MODEM is installed, and the “mode jumper”
(see Figure 3 ) is put in “Serial Shell” position, the JO-PC1 base
RS-232 port becomes active immediately following a reboot. This
allows an RS-232 connection to the “serial shell” for debugging
purposes. To re-enable the modem, you must put the mode jumper
back in the “Normal” position, and reboot again.
JENE-PC-GPRS-W

JENE-PC-GPRS
Wireless GSM cellular modem
using GPRS (General Packet
Radio Service) data technology,
powered by the controller. Requires AX-3.4 or later. One GPRS option card is supported.

Includes SMA coax tilt-and-swivel antenna.
The JENE-PC-GPRS-W model is bundled with a Wyless
provisioned SIM card. The JENE-PC-GPRS model does not include
a SIM card.
JENE-PC-SRAM Provides “battery-less” operation.
Card has static RAM (SRAM) and
integral backup capacitor for data
storage during power lost periods.
Requires AX-3.6 or later.
Does not use/affect COM port operaton.
Note: Use requires removing NiMH battery pack and any external
12V battery