Lynx Utility Series, Operator'S Manual

Page: 33 / 103

18) Trip meter reset button
To reset the meter, push the button
until all the numbers are zero (0).
These models are equipped with elec-
tronic speedometer.
It shows the
speed either in kilometers or miles
per hour.
1. Mode button
2. Engine Management System (EMS)
pilot lamp
3. Oil pressure pilot lamp
4. Cooling liquid pilot lamp
5. High beam pilot lamp
6. Battery charge pilot lamp
7. Brake pilot lamp
Electronic speed- and
tachometer
Records total distance travelled until it
is reset.
Mode button
Depress the mode button to change
display. Each time engine is started,
display shows odometer. From that
point depressing mode button again to
return the odometer.
Depressing mode button again will
change
display for the resetable
hourmeter. Push mode button again
to return to odometer.
Push and hold mode button for 2 sec-
onds to reset the tripmeter or the re-
setable hourmeter depending on the
one displayed.
Odometer
Odometer records the total distance
travelled and display it in kilometers.
Trip Meter
Records distance travelled since it has
been reset. Distance travelled is dis-
played in kilometers.
Resettable hour meter
Records engine running time in hours
and minutes since it has been reset.
Push and hold mode button for 2 sec-
onds to reset the resetable hour me-
ter.
Electronic display code
If your speedometer shows “SCALE”
in the display, it means that the display
selector button is stuck in the down
position or depressed when the elec-
trical system was activated.
At vehicle speed of 90 km/h and more
the mode LCD screen will show speed
only instead of the selected mode.
NOTE: At the electronic speedometer
display appears “9-9” when you pow-
er up the vehicle. This means that the
speedometer is calibrated to 9 teethed
drive sprocket.
19) Fuel tank cap/gauge
Unscrew to fill up tank then fully tight-
en. Fuel tank cap features a mechan-
ical gauge.
Located at rear of fuel tank cap the
gauge facilitates fuel level reading.
_____________________
31