CARE & USE/ FIRE PIT INSTALLATION
|
7
Press the ignition button and verify a spark is present at
the spark electrode at the burner assembly. If you do not
see or hear a spark, please refer to the trouble shooting
section of this manual.
If the ignition spark is present, proceed to the next step,
addition of burner media.
MEDIA INSTALLATION
BURNER AND IGNITION CONTROLS
...
continued
Step 2
STEP1:
Install the burner pan as described above
STEP2:
Add lava rocks and spread evenly to cover the entire burner assembly, and an additional ½ - 1” deep. Be careful
not to block the ignition box openings as this will affect proper ignition.
STEP3:
Add river rocks in a single layer, to cover the lava rock. The ignition box may be loosely covered with the river rocks.
Your Ice ‘N Fire Pit needs burner media in order to create realistic, natural looking flame effects. Follow the instructions
outlined below to create safe and pleasing fire effects.
INSTALLING THE LP CYLINDER
The LP Gas cylinder, or tank, must comply with U.S Department of Transportation (D.O.T.) Specifications for
LP Gas Cylinders or the Standard for Cylinders, Spheres and Tubes for Transportation of Dangerous Goods
and Commission CAN/CSA-B339. The cylinder must be protected with a listed overfill prevention device and
provided with a connection device compatible with the appliance connector. Failure to meet this requirement
may create a hazardous condition resulting in personal injury, death or damage to personal property, and may
pose a risk of fire or explosion.
WARNING