Lynx RAVE RS SERIES, Operator'S Manual

Page: 81 / 113

MAINTENANCE PROCEDURES
A01F05A
1
2
3
1. Guides
2. Slider shoes
3. Equal distance
3. To correct track alignment:
3.1 Stop engine.
3.2 Remove tether cord cap.
WARNING
Remove the tether cord cap
before performing any main-
tenance or adjustment, un-
less otherwise specified. Ve-
hicle must be parked in a safe
place, away from the trail.
3.3 Loosen rear wheel screws.
3.4 Tighten adjustment screw on
side where the slider shoe is
the farthest from the track in-
sert guides.
A01F0BA
1
2
3
1
1. Guides
2. Slider shoes
3. Tighten on this side
4. Tighten retaining bolts.
WARNING
Properly tighten wheel retaining
bolts, otherwise wheel may come
off and cause track to “lock”.
mmo2008-003-047_b
TYPICAL
1. Retighten to 48 N•m ± 6 N•m
(35 lbf•ft ± 4 lbf•ft)
5. Restart engine and rotate track
slowly to recheck alignment.
6. Reposition snowmobile on ground.
7. Install rear wheel caps if so
equipped.
Suspension
Rear Suspension Condition
Visually inspect all suspension compo-
nents including slider shoes, springs,
wheels, etc.
NOTE: During normal driving, snow
will act as a lubricant and coolant for
the slider shoes. Extensive riding on
ice or sanded snow, will create exces-
sive heat build-up and cause prema-
ture slider shoe wear.
Suspension Stopper Straps
Condition
Inspect stopper straps for wear
and cracks, bolt and nut for tight-
ness. If loose inspect holes for de-
formation. Replace as required.
Torque nuts to 10 N•m ± 1 N•m
(89 lbf•
in
± 9 lbf•
in
).
Rear Arm Lubrication
Lubricate rear arm at grease fittings
using suspension SUSPENSION
GREASE (P/N 293 550 033). Refer to
MAINTENANCE SCHEDULE
for main-
tenance frequency.
_______________
79