13
At installation do not forget to connect air temperature sensor otherwise a trouble
code will appear.
75$'ULYH3XOOH\$GMXVWPHQW
7(&PRGHOV
*HQHUDO
From factory TRA drive pulley adjustment screws are set to
position 3. This
position allows the best compromise between acceleration, top speed and fuel
economy.
Position 1 or 2 would provide the best fuel economy
. Top speed would be
reduced.
Position 4 would give the best acceleration. Fuel economy would be reduced.
$GMXVWPHQW
To gain access to drive pulley
, refer to BELT GUARD REMOVAL AND
INSTALLATION above in order to remove air silencer.
Follow the procedure described in the
2ZQHU¶V0DQXDO
.
7528%/(6+227,1*
The following chart is provided to help in diagnosing the probable source of simple
troubles. You may be able to solve many of these problems rather quickly, but
others may require the skills of a mechanical technician. In such cases, consult an
authorized Lynx dealer for servicing.
6<03721(OHFWULFVWDUWHUGRHVQRWFUDQNDQGQRSRZHUWRJDXJHV
3266,%/(&$86(6
:+$772'2
Engine cut-out switch in the OFF
position or tether cord cap away
from switch post.
Place engine cut-out switch in the
ON position and install tether cord cap on
switch post.
MPEM/fuel pump fuse burnt out.
Replace MPEM/fuel pump fuse with an
appropriate rated fuse.
6<03721(OHFWULFVWDUWHUGRHVQRWFUDQNDQGORZEDWWHU\YROWDJHSLORWODPSLVRQ
3266,%/(&$86(6
:+$772'2
Battery voltage is too low to allow
electric starter.
On 2 TEC models: try to start engine
with rewind starter and have battery
and charging system checkes by an authorized
Lynx
dealer.
4-TEC models: have battery and charging system
checked by an authorized
Lynx
dealer.
