Lynx LMD-4, Installation

Page: 2 / 5

P/N# 35832 2
FASTENERS SUPPLIED:
1) #10 X 1/2" TYPE 'A' SCREW (QTY 2)
2) #8-32 X 3/8" MACHINE SCREW (QTY 8)
3) #8-32 LOCK NUT (QTY 8)
4) #12 X 1/2" O.D. FLAT WASHER (8)
5) 1/4-20 X 1/2" MACHINE SCREW (QTY 2)
6) 1/4-20 LOCK NUT (QTY 2)
7) 1/4" X 11/16 O.D. FLAT WASHER (QTY 2)
STEP 1- ALIGN TOP INSTALLATION BRACKET WITH REAR EDGE OF UPPER DRAWER FRAME. IF THIS BRACKET DOES
NOT REACH THE DRAWER FRAME, ADD THE TOP SLIDER BRACKET AND ASSEMBLE WITH 2 SETS OF #8 SCREWS, NUTS,
AND WASHERS (ITEMS #2, #3 & #4). ADJUST THESE 2 BRACKETS SO THAT, WHEN POSITIONED BEHIND DRAWER AND
HOLES ARE ALIGNED, THE DRAWER HANGS LEVEL. SECURE THE TOP INSTALLATION BRACKET TO THE UNDER SIDE OF
THE ISLAND TOP BY FIRST PRE-DRILLING (2) 5/32 HOLES (1/2" DEEP MAX) AND INSTALLING (2) #10 X 1/2" TYPE 'A' SCREWS (ITEM #1). FASTEN THE LOWER END
OF THE BRACKET ASSEMBLY TO THE UPPER HOLE AT THE REAR OF THE DRAWER FRAME. USE THE #8 SCREW, NUT AND WASHER (ITEMS #2, #3 & #4). IF YOU ARE
ONLY INSTALLING (1) DRAWER, YOU ARE NOW FINISHED. IF MORE THAN (1) DRAWER IS BEING INSTALLED, GO TO STEP 2.
LYNX MODULAR DRAWER MOUNTING KIT
STEP 2- ATTACH THE SECOND DRAWER TO THE FIRST (TOP) DRAWER BY USING THE CONNECTOR STRAP. ALIGN THE TOP SLOT OF THE STRAP TO THE BOTTOM HOLE AT THE REAR OF THE UPPER
DRAWER FRAME. SECURE WITH #8 SCREW, NUT, AND WASHER (ITEMS #2, #3, #4). ALIGN THE BOTTOM SLOT OF THE STRAP WITH THE TOP HOLE AT THE REAR OF THE SECOND DRAWER FRAME.
REPEAT THIS PROCESS, USING THE SECOND CONNECTOR STRAP, FOR THE THIRD (BOTTOM) DRAWER.
STEP 3- ASSEMBLE THE 2 HALVES OF THE BOTTOM BRACKET INTO A 'U' SHAPE BY USING THE (2) 1/4-20 X 1/2" MACHINE SCREWS, NUTS, AND WASHERS (ITEMS #5, #6, & #7). HAND TIGHTEN
ONLY., PLACE THIS BRACKET ASSEMBLY UNDER THE THIRD (BOTTOM) DRAWER FRAME. ADJUST BRACKET ASSEMBLY UNTIL IT FIRMLY CONTACTS THE BOTTOM OF THE DRAWER FRAME. TIGHTEN
SCREWS AND NUTS SECURELY. NO ADDITIONAL FASTENERS ARE REQUIRED. PLEASE NOTE- THIS BOTTOM BRACKET IS USED FOR ADDITIONAL SUPPORT IN A 3-DRAWER INSTALLATION. IT CAN
ALSO BE USED INSTEAD OF THE TOP BRACKET ASSEMBLY IN A 3-DRAWER INSTALLATION WHERE IT IS NOT DESIRED TO DRILL INTO THE TOP ISLAND SURFACE.
Lynx Grills, Inc.
7300 Flores St.
Downey, CA 90242
www.lynxgrills.com
Lynx Customer Care
Ph.: 888-289-5969
Fax: 562-299-6978
service@lynxgrills.com