Page 2
1.2
Tools Required
z
Large and small flat bladed screwdrivers
z
Large and small crosspoint screwdrivers
z
Hammer
z
Power drill
z
5mm & 8mm masonry drill bits
z
Sharp knife
z
Pencil & bradawl
z
Wire cutters & wire stripper
z
Ladder or other safe working platform
z
Eye protection
1.3
System Features
z
Detector Learning System – every LS5000
cordless detector contains a unique
identification code; during installation the
Control Unit will learn which detectors
belong within your system by receiving
coded radio transmissions from each
detector.
z
The system can control up to 24 detectors,
16 of which can be cordless. 4 traditional
detectors (6-wire PIR or door/window
contact) and 4 two-wire detectors (2-wire
PIR).
z
To allow you to leave and enter the
protected area without setting the alarm off,
Zone 1 is set aside as an Entry/Exit zone.
When triggered, Zone 1 gives the user 30
seconds (adjustable) to unset (disarm) the
system without causing full alarm. In most
cases the Zone 1 detector will be a door
contact on your main entrance door.
z
Every system component contains a tamper
detection device. If any attempt is made to
interfere with any part of the system, an
alarm system will sound immediately even
if the system is not armed.
z
Each wireless detector transmits a signal to
the control unit to warn the user of any
problems within the detector, such as a low
battery condition.
z
Optional wired and two-wire detector give
alternative protection – they do not rely on
radio signals and hence cannot be jammed
LS1600 Wireless Passive
Infra-Red Detector
LS-1601
Wireless Door/Window Contact
CONTROL UNIT
TW402 Two-Wire
Passive Infra-Red Detector
LS1606
Remote Control Key