•The use of a power screwdriver
•Drill 4 starter holes using a 1/8”
diameter drill bit.
Recommended:
Align glide frame in cabinet as shown using
alignment guide found in parts bag
Install front
screws first
Turn screws
until just snug
LIMITED WARRANTY AND DISCLAIMER OF LIABILITY
The manufacturer warrants this product against defects in manufacturing and workmanship for a period of ninety (90) days from the
date of purchase. For questions, call (800) 733-5965 for customer service.
MANUFACTURER DISCLAIMS ALL OTHER WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE WITH REGARD TO THE PRODUCT. IN NO EVENT SHALL MANUFACTURER BE LIABLE
FOR ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS
PROFITS, INJURY TO PERSON OR PROPERTY, OR ANY OTHER INCIDENTAL, CONSEQUENTIAL OR PECUNIARY LOSS), OR FOR ATTORNEY’S FEES OR COSTS, ARISING
OUT OF THE USE OR OPERATION OF THE PRODUCT.
2”
min.
50.8cm
2”
min.
50.8cm
2”
min.
50.8cm
Check for adequate cabinet
and door clearance
Adjust glide frame position if needed
Remove assembled loops from glide frame
Move inner glide rails slightly forward as shown
Mount glide frame into cabinet using wood screws found in parts bag
Set assembled loops back onto glide frame with
mounting holes in loops and glide frame aligned.
Attach loops to glide frame using
mounting screws.
Only gently tighten
2”
min.
50.8cm
2”
min.
50.8cm
2”
min.
50.8cm
Mounting Glide Frame
Attach Loops
Make sure arrows are
pointing to the front of
the cabinet
Alignment
Guide
5
®
Roll-Out Lid Holder R10 If you have questions, please call 800-733-5965. © 2014 Lynk , Inc. 8241 Melrose Drive, Lenexa, KS 6621
Set the assembled loops and
base onto glide frame with
mounting holes aligned
Checking Cabinet Clearance
Aligning Glide Frame
6
7
4
Base
mounting
hole
Move glide
rails forward