10
Technical specifications
Audio
Parameter
Value
Note
Balanced input connectors
3-pin XLR, gold-plated
Case=Gnd, Pin1=Gnd,
Pin2=Hot(+), Pin3=Cold(-)
Balanced input impedance
10 KOhm
AC-coupled
Balanced input CMRR
40 dB
20 Hz – 20 kHz
Unbalanced input connectors Phono, gold-plated.
Case=Gnd, Tip=Hot(+)
Unbalanced input impedance 100 KOhm
AC-coupled
Max. input voltage
±15Vp AC, 0-20 VDC
Input sensitivity
2 V
200 W/8 Ohms
Voltage gain
26 dB
Output connectors
4 insulated binding posts, gold-
plated
Will accept bare wire ends up
to 5 mm diameter.
Output power, 8 Ohms
2 x 200 W
1 kHz, 1% THD+N
Output power, 4 Ohms
2 x 375 W
1 kHz, 1% THD+N
Nominal load impedance
4 - 8 Ohms
It is safe to operate the
amplifier with no load.
Frequency response
0.3 Hz – 33 kHz
-3 dB points, 8 Ohms load.
Frequency response
-0dB/+0.2dB
20 Hz - 20 kHz, 8 Ohms load
Frequency response
-0.2dB/+0dB
20 Hz – 20 kHz, 4 Ohms load
Output impedance
0.035 Ohms
20 Hz - 1 kHz
Output impedance
0.4 Ohms
20 kHz
THD+N, 1 W /8 Ohms
0.004%
A-wgt.
THD+N, 1 W/4 Ohms
0.006%
A-wgt.
THD+N, 100 W/8 Ohms
0.01%
A-wgt.
THD+N, 180 W/8 Ohms
0.07%
A-wgt.
THD+N, 275 W/4 Ohms
0.07%
A-wgt.
S/N ratio
117 dB
A-wgt. ref 200 W/8 Ohms.
Channel separation
84 dB
1 kHz, 200 W/8 Ohms.
Peak output current
±40 A
Output common mode voltage 35 VDC
Ref. Ground. The amplifier can
not be used in bridged mono
mode
Output DC voltage
±5 mV
All audio measurements, except frequency response, are measured with a 20KHz low-pass
filter in accordance with AES-17.