LX MOP2
March 2018
Page 5 of 10
3
Fitting MOP2
Figure 1: MOP2 dimensions
Figure 2: Hall current sensor dimensions
•
Install MOP2 and Hall current sensor close to the positive lead of battery of the E-motor (refer
to Figure 1 and Figure 2 for detailed dimensions)
•
Unscrew the screw holding the hall current sensor frame closed and then open it
•
Place the positive lead cable from the battery through the open hall current sensor (refer to
Figure 3 for positive current flow), close the frame and screw it back
•
If the cable going through the sensor is not fixed entirely (too small diameter) we recommend
padding the section of the cable that goes through the sensor before final fixing. If the cable
is not fixed, there will be errors in measurements!
