Preparing an LXE Device for Remote Management
Preparing an LXE Device for Remote Management
Two additional utilities are necessary for remote management. These utilities are included on CE mobile devices
manufactured after April 2007.
l
The
LXE Remote Management Utility (RMU)
must be installed on all LXE mobile devices first – then you can control
mobile device reboot, storage RAM adjustment, real-time updates and Avalanche Enabler properties. If the RMU is not
already installed on the MX3Plus, see
Using Wavelink Avalanche to Upgrade System Baseline
.
If in doubt, verify RMU.CE.CAB exists in the \System folder. If the RMU.CE.CAB file is present when the Enabler is
installed, the RMU is also installed.
Important
: If the OS package includes double-byte Asian fonts, the storage RAM property of the RMU must be higher
than the default value (40MB).
If the amount of storage RAM is too low, the Enabler returns a “Mobile unit out of resources” error.
To determine the minimum value required, inspect the RMU.StorageRAM>=
nn
parameter in the Criteria field for the OS
package. Generally, this setting should be approximately 40 MB above the amount of RAM in use on the device for a
standard OS and 50MB above the amount of RAM in use for an OS with Asian fonts.
For example, if after installing all the software, the device shows 5MB in use, this setting should be about 45MB for a
standard OS, 55 MB for an Asian font OS.
l
Use the LXE
Wireless Configuration Application (WCA)
when you want to remotely manage the Cisco client or
Summit client device. This utility is downloaded and installed in addition to the LXE Remote Management Utility. The
WCA is included when the Summit or Cisco radio driver software is updated. The WCA is automatically installed when
the radio driver is updated.
If the LXE Remote Management Utility (RMU) is not present on the MX3Plus, see
Using Wavelink Avalanche to Upgrade
.
E-EQ-MX3PLUSRG-J [ 158 ] MX3Plus Reference Guide
