LXE MX1-IS, Reference Manual

Page: 74 / 164

64 BIOS Setup
MX1 I-Safe Reference Guide E-EQ-MX1ISRG-F
Exit Menu Options
To edit parameters, use the up and down arrow key to move from parameter to parameter.
Press F1 to activate the help screen then use the panning function to move around the help screen.
Press ESC to close the help screen.
Use the left and right arrow keys to move from menu to menu.
Press the ESC key or key sequence to go directly to the Exit Menu.
As changes are made to Setup values and the values saved, the next time the MX1-IS is turned on
or rebooted, those saved values will be in effect.
Save and Exit
Use this option to immediately save current Setup settings to CMOS RAM and into the Flash Boot
Device (FBD).
When “Save and Exit” is highlighted, press <Enter> to save. When the saving process is
complete, press <Enter> again to exit and reboot with the current values.
Exit w/o Save
Use this option when any current changes made to Setup parameters are to be ignored. The
parameters revert to their state when Setup was entered.
When this option is highlighted, press <Enter> and the boot process continues. The system
reboots with unchanged values.
Load Defaults
This option is used to reset the Setup values to the original, default values that were set at the
factory, before suppliers or end users made changes.
As changes are made to Setup values and the values saved, the next time the MX1-IS is turned on
or rebooted, those saved values will be in effect.
Save this change by selecting “Save and Exit.”
Load Previous
Use this option to immediately restore CMOS RAM and update the current Setup settings from
the Flash Boot Device.
Save this change by selecting “Save and Exit.”
Save Changes
Used to save BIOS Setup changes without rebooting. The changed parameters will be in effect the
next time the MX1-IS is powered on or rebooted.
Reboot by selecting either “Exit w/o Save” or “Save and Exit.”