INSTRUCTION MANUAL
13C20
SAVE THIS INSTRUCTIONS
LED-BP-SLIM Series
1. To prevent electric shock, switch off the mains power supply until installation is complete and AC
power is supplied to this product.
2. This product requires an un-switched AC power supply of 120-277V, 50/60Hz.
3. Make sure all connections are in accordance with the National or Canadian Electrical code and
any local regulations.
4. To reduce the risk of electrical shock, disconnect both normal and emergency power supplies
and connector of this product before servicing.
5. It can provide minimum 90 minutes illumination under the emergency mode.
6.
The product is UL Listed for field installation, and use with grounded.
7. The LED-BP-Slim units are suitable for use in dry or damp locations. Do not mount in or near
gas, heaters, air outlets or other hazardous location.
8. Use this product in 0°C
minimum,
55°C
maximum ambient temperatures (Ta).
9. Do not attempt to service the batteries. A sealed, non-maintenance battery is used that is not
field replaceable. Contact the manufacturer for information or service.
10.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition and void warranty.
11. Do not use this product for other than intended use.
12. Installation and service should be performed by qualified service personnel.
13. This product should be mounted in locations and at heights where it will not readily be subjected
to tampering by unauthorized personnel.
E206507
BC
IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
LINEAR EMERGENCY EQUIPMENT
UNIVERSAL INPUT
THIS PRODUCT CONTAINS A RECHARGEABLE LI-ION BATTERY.
THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
Li-ion
