3
1.
Initial set-up
1.1.
Model SPR-01
The Spectroradiometer model SPR-01 consists of three parts:
•
The control module and detection fiber
•
The detection head (light integrating module)
•
A USB cable
Assemble the instrument as indicated below. The connection of the blue fiber optic
cable to the detector should be ‘finger tight’. Do not use any tools and do not force.
The calibration parameters for your instrument have been determined with the same
components with which it was supplied. Individual parts are not interchangeable.
Place detector in
Corner for verification
Spectroradiometer
SPR-01 - 235-850 nm
Detector
Optical fiber
Control Module
USB cable
Verification
lamp
Figure 1.1
: Schematic diagram for SPR-01
Optical fibers are fragile and cannot be bent at any angle. The minimum momentary
bent radius is 60 mm, and the minimum long term bent radius is 100 mm (4 inches).
Assemble your instrument as indicated above, and connect the USB cable to an
available port in your computer. Software installation is explained in Section 3 of
this manual.
1.2.
Model SPR-02
The Spectroradiometer model SPR-02 consists of two parts:
•
The control module that with its built-in detection head (light integrating
module)
•
A USB cable
SPR-02 is sold fully assembled. Only the USB cable needs to be installed and
connected to the computer. Software installation is explained in Section 3 of this
manual.