w w w . l u z n e g r a . n e t
Operation Manual:
1.
Configuration and functions:
Configuration:
Connect the charging cable at the beginning, followed by the power cord. Make sure that a short circuit cannot occur between the connecting cable before
turning on the power.
Then configure the steps as follows:
Press the “On/off” button to turn off the controller before setting the menu.
Press the “up” and “down” button once at a time, and the LED will light up at this time. Then press the “Mode/ Speed” button to access the menu settings
screen.
The first setup screen is for “High Speed and Low Speed Settings”, and the LED will show “S-HI” or “S-LO”. Then press the “up” and “down” button to
select the mode. (If the IC in the light bar is the high speed mode, you must choose “S-HI” and choose “S-HI” when the speed is low). The factory default
is for high-speed mode.
Continue to press the “Mode/Speed” button to enter the second screen:
“Setting checkpoints”. The 4-digit LED display is for the number of control points. To increase or decrease the number press the “up” and “down” button
(long press can be adjusted quickly). The factory default is 50.
After setting it up properly, press the “On/off” button to save and exit.
Functions:
There are 4 buttons in total on the control panel, the function of each button is as follows:
On/Off:
you can turn the output on or off.
Mode / Speed:
Mode setting function switch / speed setting (the first LED shows H for model adjustment, displays S for speed adjustment).
UP:
Mode + / Speed + button. When in the mode slider function, it is for “+” mode. When in the speed slider function, it is for “Speed+”.
DOWN:
Mode/speed button. When in the mode slider function, it is for “Mode-”. When in the speed slider function, it is for “Speed-”.
A.
Mode setting/speed setting function switch (first LED shows H for model setting, displays S for speed adjustment).
B.
Mode + / Speed + button. When in the mode slider function, it is for “+” mode. When in the speed slider function, it is for “Speed+”.
C.
Mode/speed button. When in the mode slider function, it is for “Mode-”. When in the speed slider function, it is for “Speed-”.
D.
On/Off button: you can open or close the output.
Synchronous Controller System Description:
The synchronous control system can be made of any number of controller connections. Each of the subcontrollers would follow the first master controller
for permanent synchronous change. And there’s no delay.
After connecting the wiring diagram, you do not need to configure the subcontroller. It will be according to the master to control the speed and the mode
change. (That wouldn’t be synchronous when it’s turned on. You can close and open to be synchronous) When the master is working and the subcontrol
works well, the green signal light of the subcontrol will flash. The digital LED shows the working mode.
DOGITAL LED
DIGITAL CONTROLLER WITH IP20 SENSOR
BARCELONA
C/ Carles Buhigues, 13
08420 Canovelles
Tel: +34 938 402 598
MADRID
C/ Minas, 35-37
28923 Alcorcón
Tel: +34 916 416 081
PARIS
113 Avenue Joffre
77450 Esbly
Tel: +33 (0) 160 426 585
