QUiCK inStAll gUide
AssEmbLE ThE RAnGE ExTEnDER sysTEm
1. Connect the two X-WAV antennas to the
antenna mount. Position the antennas so the
N connectors are above the antenna mount
(Figure 1).
2. Attach the antenna mount to the top of the
enclosure using the washers and nuts
provided.
3. If mounting the Pro-WAV 200 high in your Wi-Fi
coverage area the antenna mount may be bent
slightly downward to focus signal into the desired
coverage area
4. Mount the AP to the enclosure using the included Velcro mounting strips.
WIRInG ThE RAnGE ExTEnDER sysTEm
1. Remove the stock antenna from your AP. Set
aside the stock antenna, you will not need it for
this installation.
2. Find the N Male to RP-SMA coax connected to
the side of the Shock-WAV Wi-Fi Signal booster
labeled “AP” (Figure 3) and connect it to the
antenna port of your AP.
3. Find the N Male to N Male coax cables
connected to the splitter that is attached to the
Shock-WAV Wi-Fi Signal Booster on the side labeled “Antenna” (Figure 3).
4. Feed the coax cables through the round pass through hole in the top of
the enclosure, (Figure 2) and connect them to the X-WAV antennas.
FIGURE 1
FIGURE 2
WA
P
POE
OUT
POE
IN
ANTENNA
48V
DC IN
FIGURE 3
