2
3
ENGLISH
ENGLISH
Specifications
Power:
220-240 V~, 50 Hz
Desoldering iron:
24 V, 90 W
Temperature range:
160 - 480 °C
Start
Place the desoldering station on a flat surface in a well ventilated area. Attach the
sponge part and place the stand piece in it. Attach the black plastic seal inside the end
of the vacuum cable. Connect the power and vacuum cables from the gun to the station,
tighten the plug nuts as well. Make sure the vacuum cable doesn't get tangled up or
twisted as the suction power can severely diminish. Place the desoldering gun in the
stand. Connect the wall plug to a wall socket. There are two extra soldering tips, five
waste container filters and three cleaning pins included in the package.
Use
Turn the power switch on the back off the desoldering station to on.
The soldering iron will heat up.
Use the
o
C /
o
F button to change between Fahrenheit (F) and Celsius (C).
Use the + and - buttons to set the right temperature.
The display will show the temperature that has been set and the temperature of the tip.
Turn the circuit board or part you want to remove solder from backwards so you can
access the pins of the components you want to remove. Push the tip of the gun over
the pin. When the hot tip has melted the solder press the trigger on the desoldering gun
to suck up the solder into the waste container of the gun. Repeat the process on each
solder point until you can remove the component from the circuit board. Be careful with
the hot tip so you don't damage the components. Turn down the safety latch to be able
to detach the waste container. Empty the container when done, be careful with the hot
solder.
To turn off the desoldering station, turn the power switch to off.
Safety information
The tool must be placed on the stand when not in use. Be careful when using the
appliance in places where there are combustible materials. Do not apply the heat gun
to the same spot for longer periods of time. Do not use the heat gun near explosive
materials. Be aware that heat may transfer to combustible materials that are out of
sight. Place the appliance on it's stand after use and allow it to cool down before
storage. Do not leave the appliance unattended when it is switched on. This appliance
can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children should be supervised to ensure
that they do not play with the appliance. Keep the appliance and it's power cable out
of reach of children younger than 8 when it's switched on or is cooling down. Protect
yourself against electrical shocks: Avoid touching grounded parts with your body e.g.
pipes, heating radiators and so on. Do not use the tool in a moist or wet environment.