Instructions For -
Electrical Assembly
Cable-Track™ Management System and Cord Wrap
Your Endura mobile equipment table incorporates the Cable-Track™
cord management system. This exclusive feature manages electrical
cords, keeping them safely out of the way. This system includes a
3-outlet, 15 foot surge suppressing electric assembly (U.L. and C.S.A.
listed) which is built into the safety handle. Please review these instruc-
tions carefully to maximize the added safety provided by Luxor’s Cable-
Track™ cord management system.
Parts List
1 - Surge protected power cord
1 - Power cord retainer clip
1 - Cord wrap
2 - “E”-clips
4 - Cord management ties
4 - Sheet metal screws
ILLUSTRATION A
Important
1
. The electrical unit should
be assembled first.
Cord wrap must be installed on leg
before assembly of complete unit.
*See below (See Illus. B).
ILLUSTRATION B
Install correct size leg on
top shelf then slide cord wrap
down over leg into position.
4
Thread power cord through
cord retaining track, secure with
cord management ties by wrap-
ping tie around cord and fasten-
ing. Cut off any unnecessary
extra length of tie. Wrap remain-
ing cord around the cord wrap
bracket. For safety and new
appearance, secure cord plug
to cord by utilizing plug snap.
2
Secure power cord plug man-
agement ties into starter holes
with sheet metal screws.
5
Each unit comes complete with two E clips
as shown below. These fit to the legs.
6
Position E clip as
shown. Route your
cord going to equip-
ment on lower shelf
through clips for a
safe and organized
cord management
system.
3
Firmly seat electric assembly 3 plug unit into
handle plug housing as illustrated. Secure
with power cord plug retaining bracket.
CORD
MANAGEMENT
TIE
CABLE GROMMET HOLE
CORD RETAINING
TRACK
3 PLUG UNIT
POWER CORD
PLUG RETAINING
BRACKET
3 PLUG UNIT
PLUG HOUSING
CORD WRAP
CORD RETAINING
TRACK
CORD
MANAGEMENT
TIE
TIES
E CLIP
