Luxman L-509X, Owner'S Manual

Page: 24 / 28

22
Before Asking for Repair Services
While in use, this unit may display phenomena which may be confused as malfunctions. Before contacting your country’s official
LUXMAN distributor for repair services, please read the operating instructions and operating instructions for any connected input and
through output devices and check the troubleshooting table below. If the cause of the malfunction cannot be identified, please con-
tact your dealer. After LUXMAN’s representatives have accepted your request for repair services, inspection fees and transportation
expenses may be claimed, even though the unit may be found to be operating normally.
Problem Cause Solution
No power is supplied even
though the operation switch is
pressed. • The power plug is disconnected from the
wall outlet, or it is not completely inserted.
• Insert the power plug in the wall outlet com-
pletely.
• The power plug is disconnected from the
AC inlet, or it is not inserted completely.
• Securely insert the power plug in the AC
inlet.
No sound is generated. • The volume control is set to the minimum
level.
• Rotate the volume control clockwise to ad-
just the sound volume.
• The input selector is not set to the source to
be reproduced.
• Set the input selector to the source to be
reproduced.
• Cable connections are incomplete. • Make cable connections securely.
• The output level of the input device is set to
the minimum position.
• Adjust the output level.
• The separate switch is set to on. • Set the separate switch to off.
• The mute switch of the remote control is set
to on.
• Set the mute switch to off.
No sound is generated on one
side. • The balance control is fully rotated. • The balance control shall be set to the cen-
ter position under normal conditions.
• The connecting cable is not connected on
one side only.
• Make cable connections securely.
Humming sound (boon or zzz
noise) is generated. • The ground side of the pin-plug cable has
no contact with the terminal.
• Make connections securely so that the
ground side of the pin-plug cable can be
connected.
• The ground wire of the analog record player
is not connected.
• Connect the ground wire of the analog
record player to the GND terminal.
• Connections or mounting conditions are
incomplete between the cartridge and shell,
or between the shell and tone arm of the
analog record player.
• Connect (or mount) the cartridge, shell, and
tone arm securely.
No effect of tone control or
balance control is observed. • The line straight switch is set to on. • When tone control or balance control is
used, the line straight switch shall be set to
off.
The subsonic, monaural or
loudness is not activated. • The line straight switch is set to on. • When the subsonic, monaural or loudness
is used, the line straight switch shall be set
to off.
The lights of the power meters
are not turned on. • The meter switch is set to off. • Set the meter switch of the remote control
to on.
The separate switch of the
remote control is not activated. • To prevent incorrect operations, this unit is
designed to toggle the separate on/off by
holding down the separate switch approxi-
mately for approx. 1 second.
• Hold down the separate switch of the
remote control for approx. 1 second.