Product/Service Information
Luxium Lighting
Bring out your Colors!
Luxium Lighting
7624SE 7th Ave.
Portland, OR 97202
Phone: 503.780.4306
E-mail: [email protected]
ZR30
Adaptable-Color
DMX Lamp
WARNING: The ZR30 is powered by a
switching power supply and is not intend-
ed to be dimmed by a line-voltage dim-
mer. Socket should be wired directly to
the power-line mains.
Accidental connection of RJ45 jacks to
non-DMX512 equipment (e.g., an Ether-
net Hub at a patch bay) may result in
damage to equipment.
RJ45 jacks for
DMX in/out
DIP Switch for DMX addressing
and built-in functions
Attachment of
optional diffusers
Edison screw base
for AC power
Installation
The Luxium
TM
ZR30 is a self-contained
PAR-30 size LED lighting solution capa-
ble of DMX512 or stand-alone operation.
It has a wide input power supply, so will
operate on any voltage that your likely to
find on an E26/E27
“
medium screw
base
”
lamp socket.
The ZR30 has five operating modes that
are selected via an 8-position DIP switch
on the side of the lamp.
The ZR30 may be connected to a
DMX512 controller via the RJ45 jack,
also on the side of the lamp. Multiple
ZR30s may be daisy-chained onto a sin-
gle DMX512 cable.
If installed in a fixture please leave at
least ½ inch (12mm) of clear space sur-
rounding the ZR30 housing to facilitate
air flow.
Voltage: 90VAC
…
250VAC, 50/60Hz
Power: 25W (at maximum output)
Environmental: 5C
…
45C, 10-90%RH
non-condensing.
Control Input: DMX512-A on RJ45 con-
nector as described in ANSI E1.11-2008
Optional Diffuser Kit
The Luxium
TM
DK1 Optical Diffuser Kit is
a set of 5 different filters that are used to
adjust the beam angle of the ZR30.
This is an excellent option for creating a
smooth and uniform beam with the ZR30
lamp. These filters are easy to install on
the front of the lamp and are held in place
by the bezel ring.
Useful for situations that require a more
diffuse beam that spreads out over a wid-
er angle than the standard narrow beam
spot light.
Beam spread can be adjusted from 30
degrees to 60 degrees depending on
the chosen insert.
Install diffuser film under tabs around
lamp bezel. Use slight pressure to gen-
tly bend diffuser film and snap into
place.
Copyright - Luxium Lighting 2016
Specifications subject to change without notice
