LX502
V. 02 – 31/10/2013
7
©Velleman nv
the device will not function after 30 seconds, discontinue operation to avoid permanent damage. Return the
device to your dealer. Remember to drain the reservoir before transporting the unit.
Using the device will produce water drops at the smoke outlet. This is perfectly normal.
A little smoke may continue to escape from the smoke outlet after operation.
7.2
Control Panel Navigation
Access the control panel functions using the four panel buttons located directly underneath the display
[6]
.
From left to right:
Button
Function
<MENU>
accesses the menu and scrolls through the menu options
<UP>
scrolls through the menu options in ascending order, or increases a numeric value
<DOWN>
scrolls through the menu options in descending order, or decreases a numeric value
<ENTER>
used to select and store the current menu or option within the menu
The control panel display shows the menu items you select from the menu map. When a menu function is
selected, the display will show immediately the first available option for the selected menu function. To
select a menu item, press <ENTER>.
Use the <UP> and <DOWN> buttons to navigate the menu map and menu options. Press <ENTER> to
access the menu function currently displayed or to enable a menu option. To return to the previous option
or menu without changing the value, press the <MENU> button.
7.3
The Fluid Sensor
This device is equipped with a fluid sensor to protect the pump. The sensor tests whether there is fluid inside
the supply pipe. If not, the device shuts off the pump after 20 s and the display starts flashing.
In this case, switch off the device and refill the reservoir with smoke liquid.
If the display keeps flashing after you refill the reservoir, you need to reset the fluid sensor. Proceed as follows:
Switch off the device, then switch it on again.
Or, from DMX operating mode: set channel 1 to off (DMX value 0–9), then set to on (DMX value 10 or
higher).
Caution
: We strongly recommend that you
keep the fluid sensor enabled
at all times. If not, the
device may be permanently damaged if it works without fluid. Note that this damage is not covered
by the warranty.
To check if the fluid sensor is enabled, proceed as follows:
1.
Press <MENU> until <oiL> is displayed and press <ENTER> to confirm.
2.
If the display shows <off>, use <UP> or <DOWN> to select <on>.
3.
Press <ENTER> to confirm.
The fluid sensor is now enabled and the pump is protected.
7.4
LED Colour Selection
In stand-alone mode, the LEDs light up while the device produces smoke. You can choose the colour of the LED
beam in the settings menu.
Note
: In DMX mode, the LEDs are controlled via DMX signals. See the DMX values table further in this manual
for an overview of all the possibilities.
To choose the colour of the LED beam for stand-alone mode, proceed as follows:
1.
Press <MENU> until <Colo> is displayed and press <ENTER> to confirm.
2.
Use <UP> or <DOWN> to select the desired colour:
o
<OFF>: to switch the LEDs off. The LEDs do not light up while the device produces smoke.
o
<Co1>–<Co9>: to select one of the predefined colours (red, green, blue, pink…).
o
<rand>: to choose a randomly changing colour. The LEDs change colour every second while the device
produces smoke.
3.
Press <ENTER> to confirm.
7.5
Operation With Remote Control
To use the device with the remote control, wait until the device has heated up, and then press the button on
the remote control. The LEDs light up in the selected colour and the device produces smoke during 5 seconds.
The LEDs go out when the machine stops producing smoke.
