Product Name:
Cement/Polyresin Whiskey Barrel Patio Fountain with Planter and LED Lights
SKU #:
WHF841
Contact: [email protected]
Instruction Manual
Please save this manual for future reference.
1.
Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2.
Select a flat, level surface for the assembly and final location of your fountain.
3.
Place the fountain on a flat, level surface. From the opening at the top of the fountain base, insert the water
supply tube into the pump outlet. Place the pump upright in the basin and draw the pump power cord out
of the fountain top. Tighten LED connector to the pump connector. Insert pump cord to adapter and tighten.
(①)
4.
Add clean water into the basin. The water level should be approximately 30mm lower than the edge of the
basin. (
②)
5.
Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin
to function as intended.
(③)
6.
To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area
where it cannot be damaged.
7.
Do not leave your fountain running for extended periods of time when no one is present to observe the
performance.
8.
Check the area around your fountain on a regular basis to ensure that there is no leakage.
9.
Please refresh the fountain with water each week to ensure it in good condition.
10.
Do not add any harmful chemicals to the water as it may alter the paint finish.
