LiteRise operation
To tilt the slats:
Simply rotate the wand to tilt the slats from fully closed
to any desired angle.
To lower and raise the blind:
Simply push up using the bottom rail to raise the blind
and pull down on the bottom rail to lower the blind.
Motorised operation
For motorisation information, please refer to SOMFY
®
,
Merger
®
or PowerView
®
product brochure that is
supplied with your blinds.
Care and cleaning
Routine maintenance
Dusting
Dust can be easily brushed off using a clean soft
cloth, a feather duster or a vacuum cleaner with
brush attachment.
To dust, tilt slats up and then down, to reach the top
and bottom surfaces.
IMPORTANT NOTE
• Do not allow water to come into contact with
the timber. Although the timber is coated,
if water comes into contact with the timber
it can cause the slats to warp, bow or twist,
water stains to occur or the paint or lacquer
to peel.
• Do not use a damp cloth when cleaning.
Damage to the blind caused by water is not
covered under the warranty.
Operation
Manual Cord Lock operation
To tilt the slats:
Pull on one of the single cords to tilt the slats in one
direction, and pull on the other cord to tilt the slats in the
opposite direction.
To raise and lower the blinds:
Raise and lower the shade manually and lock in place
with the cord lock. Wind excess cord around the cleats.
The cord lock has a locking device that holds the cords
in place when they hang vertically down. To raise or
lower the blind, pull the double cords towards the
middle until you hear the cord lock disengage. When the
blind is at the desired height, return the cord to the side
of the blind to re-engage the cord lock.
IMPORTANT:
When raising or lowering the blind, the
slats should be in the open position.