Assembling your Luvelo Ultra Power Juicer
P/7
Before using your Juicer
After unpacking your juicer, wash all parts except the motor base in hot soapy water. Rinse and dry
thoroughly.
Important: Always ensure your juicer is unplugged from the power outlet when not in use, during
assembling or whilst removing parts.
1. Set the motor base on a dry, level surface. For convenience when juicing, have the control
switch facing you.
2. Place the pulp container onto the specifically designed pulp container foot rest.
(When you have clipped the juicer collector bowl into place the pulp container will
be secure).
Tip: To reduce cleaning we recommend that you line the pulp container with a plastic bag
to collect the pulp.
3. Place the juicer collector bowl onto the top of the motor base. It will clip securely into
position.
4. Position the stainless steel blade and filtering basket onto the motor drive shaft and push
down until firmly in place. (You may need to rotate to get into correct position).
5. Place the feed chute and cover onto the juicer collector bowl, with the feed chute positioned
over the stainless steel blade and filtering basket and push into position.
6. Secure the juicer cover by raising the twinlocking handles and clip the tops to the juicer
cover. Press firmly on the lower part of the twin-locking handles to lock into place.
Please note: The juicer will not power on until the twin-locks have been clipped into place.
When twin-locks are clipped into place and the juicer is switched on at the power point, then
the red LED light will come on around the control switch.
7. Take the food pusher, align the groove on the food pusher with the notch on the inside of
the feed chute and slide the food pusher down into the feed chute.
You are now ready to switch the juicer on and begin juicing.
Operating your Luvelo Ultra Power Juicer
P/8
Please note: The juicer should be completely assembled before use.
1. Ensure the control switch on the juicer is in the off ‘0’ position and insert the power cord into a
230-240V AC power outlet and turn the power ‘On’.
2. Clean fruit and vegetables thoroughly, ready for juicing.
Note: The extra large feed chute allows whole fruit and vegetables to be juiced, however
some fruit and vegetables may require other preparation before juicing, such as peeling
and removing stones. See page 9 for tips and techniques.
3. Ensure that the juicer has been assembled completely and correctly, making sure that the
stainless steel blade and filtering basket revolves properly before placing fruit and vegetables
in the juicer.
4. Place the 1.5 litre jug under the juice spout.
5. Select 1 or 2 speed with the control dial. For optimum juicing results speed 1 is used primarily
for soft fruit and vegetables, particularly those with a high water content and speed 2 is ideal for
hard and fibrous fruit and vegetables.
Please note: When speed 1 or 2 is selected, the control switch LED light will change
from red to blue to indicate the juicer in now ready for operation
6. With the juicer in operation, place the fruit and vegetables into the feed chute. Using the food
pusher, guide the fruit and vegetables down the feed chute and onto the stainless steel blade.
Tip: For maximum juice extraction, guide the food pusher down the feed chute in a slow
downward motion.
Important: Do not push fruit or vegetables into the feed chute with your fingers, always
use the food pusher provided.
7. The juice from the fruit and vegetables will flow directly into the jug.
Important: When juicing be aware of the level of pulp in the pulp collection container,
because if the container is overfilled this can cause damage to the appliance and
prevent the juicer from operating correctly.
8. When juicing is complete, ensure that the juicer is switched ‘Off’ and unplugged from the
power outlet.
