2)Power on the meter, Immerse the above pH electrode
into the measuring solution.
The " Display " ( 3-1, Fig. 1 ) will show the pH value,
in the same time the " pH indicator " ( 3-10, Fig. 1 )
will light.
3)Press the " PH/Temp Button " ( 3-7, Fig. 1 ) once,
the " Temp. indicator " ( 3-11, Fig. 1 ) will light, the "
Display " ( 3-1, Fig. 1 ) will show the Manual Temp.
value.
* Press the " " PH/Temp Button " ( 3-7, Fig. 1 ) once again,
the " Display " will return the " pH value ", in the
same time the " pH indicator " ( 3-10, Fig. 1 ) will light again.
* The pH measurement value will be compensated
by the Manual Temp. value.
* The default " Manual Temp. value " is 25 .
℃
* The procedures to set the Manual Temp. value, refer
to page 11.
* The method to change the default Manual Temp. unit from the
to , refer to page 10.
℃
℉
4-5 1st layer setting procedures
LoLt
Low Limit
HILt
High Limit
Low Limit Value Setting
1)Press the " Set Button " ( 3-4, Fig. 1 ) once, the
" Display " will show " LoLt ", now the meter is ready
for the pH " Low Limit " value setting.
Press the " " PH/Temp Button " ( 3-7, Fig. 1 ) once,
the " Temp indicator " ( 3-11, Fig. 1 ) will light, now
the meter is ready for the Temperature " Low Limit "
value setting.
8