2
3
Installing the Tabletop Master Control
Activate Tabletop Master Control.
Press and hold any button on the
Tabletop Master Control until the
LEDs on the Tabletop Master Control
start flashing (approximately two
seconds) and the Central Antenna
beeps, indicating the Tabletop
Master Control has been activated in
the system.
2
Before the Tabletop Master Control may be used to control lights in the AuroRa® System,
it must be activated. The Tabletop Master Control can be activated in the system using
either the Central Antenna (AR-CA-WH) or the Security Interface (AR-SI-WH). The pro-
cedure below refers to the Central Antenna; however, the procedure is the same for the
Security Interface.
Activating the Tabletop Master Control
1
Enter Add Mode.
Press and hold the Add button on
the Central Antenna until the Add
LED begins to flash (approximately
3 seconds). The Central Antenna will
beep.
Dimmers that are in the System will
flash their lights.
3
Exit Add Mode.
Press and hold the Add button until
the Add LED stops flashing and
remains off
(approximately 3 seconds). The
Dimmers will stop flashing their lights
and the Central Antenna will beep.
4
The Tabletop Master Control has
now been activated.
Apply power to the Tabletop Master Control.
1
2
Find a suitable location for the Tabletop Master Control.
Place the Master
Control in a convenient and accessible location.
Note:
Tabletop Master Controls
must be located within 30 feet (10 m) of a Central Antenna or Security Interface.
Installation
Plug in power
cord and
adapter
Central Antenna shown;
Security Interface may
also be used
