Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036-1299, U.S.A.
Made and printed in the U.S.A. 2/08 P/N 044-109 Rev. A
Warranty: For Warranty information, please see the Warranty enclosed with the
product, or visit www.lutron.com/resiinfo.
These products may be covered under one or more of the following U.S. pat-
ents: 5,838,226; 5,848,054; 5,905,442; 6,687,487; 6,803,728 and correspond-
ing foreign patents. U.S. and foreign patents pending.
Lutron, AuroRa and the sunburst logo are registered trademarks of Lutron
Electronics Co., Inc.
© 2007 Lutron Electronics Co., Inc.
1
ARMC-5T
Troubleshooting
Symptom
The Tabletop Master Control is not
communicating with the system.
Cannot activate Tabletop Master Control
Possible Cause
Tabletop Master Control has not been activated in the system.
• Activate Tabletop Master Control in the system, following the instructions
on page 3.
A maximum of one (1) Tabletop Master Control can be activated in the
system.
• Call the Lutron Technical Support Center at +1.800.523.9466 for
assistance.
Operating the Tabletop Master Control
Installation Instructions for
Replacement Tabletop Master Control
Read all instructions completely before installation.
AuroRA
®
Tabletop Master Control
ARMC-5T
DC Adapter: 9 V
300 mA
DC Adapter for Tabletop Master Control
T120-9DC-3-WH
Input 120 V
60 Hz 6.5 W; Output 9 V
300 mA
Overview
The ARMC-5T Tabletop Master Control is for use
with
AuroRa
systems in conjunction with the Central
Antenna (AR-CA-WH) or Security Interface (AR-SI-
WH), and allows the wireless activation of
AuroRa
Dimmers / Switches.
Important Notes
Environment:
Ambient operating temperature: 32 °F
to 104 °F (0 °C to 40 °C). 0% to 90% humidity, non-
condensing. Indoor use only.
Finish:
Do not paint the Tabletop Master Control.
Cleaning:
To clean, wipe with a clean damp cloth.
Do noT use any chemical cleaning solutions.
Power:
Use only the adapter provided by Lutron
(T120-9DC-3-WH) with your Tabletop Master Control.
Using an adapter not rated at the following specifica-
tions could damage the control and possibly overheat
the adapter.
• Input: 120 V
60 Hz
• output: 9 V 300 mA nEC
®
Class 2; IEC PELV
Radio Frequency Range:
The Tabletop Master
Control should be located within 30 feet (10 m) of
the Central Antenna or Security Interface. The per-
formance of the Tabletop Master Control is highly
dependent upon a variety of
complex factors such as:
• Distance
• Construction of walls
• Electrical equipment nearby
System Control:
Before the Tabletop Master Control
may be used to control lights in the
AuroRa
system, it
must be activated.
5
4
3
2
1
All on - Turns
all dimmers on
to full
Buttons - Turn individual
dimmers on to local
dimmer slider level
All off - Turns
all dimmers off
FCC Information
Note:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC rules. Operation is subject to the following: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
5
4
3
2
1
T120-9DC-3-WH
