The Bluetooth Remote comes together with the Peppi V5 barmount.
On the bike, the best way to mount the remote is directly next to your grips
so you have full control and don't need to take off your hands while riding.
Peppi V5 also available for 32mm, Art. No.: 1086
Connecting the transmitter to the light:
For establishing a connection, the receiving mode of the lamp has to be
activated. By default, your lamp has already been connected to the transmitter.
After the lamp turns on, by activating the e-bikes battery, the lamphead is in
receiving mode for 15 seconds. During this time, press the remote control’s
big button for about 5 seconds, until the remote confirms by lighting up blue.
Release the button immediately.
Low button cell:
With decreasing voltage, the remote control LEDs will shine less bright.
Also cold temperature does reduce the battery voltage. If the button cell is
near empty, it's shown by a red light.
Transmitter battery change:
To change the transmitter button cell a T5 torx screw driver is needed.
Insert the new CR 2032 button cell as shown and close
the transmitter again.
Tighten the screws until the blue sealing is visibly squeezed.
T5 torx screw driver: (Art.No. 137)
Bluetooth remote control
