Lunar DPX-IQ, Operator'S Manual, Page: 135 / 166

DPX-IQ Operator’s Manual Specifications H-5
• Shock and Vibration: Make sure the scan table does not receive shock greater
than 1 G for more than 1 millisecond. Make sure the scan table does not receive
vibrations greater than 0.25 G at 5 Hz.
• Temperature: Make sure the temperature during system operation is 65°F–81°F
(18°C–27°C).
NOTE: When the system is turned off, or there is a power failure, you must
turn the system on and let it warm up for one hour. After one hour,
complete a Quality Assurance procedure.
H.5 Power Specifications
H.5.1 Leakage Current
Total System with Isolation Transformer: <100 microamperes.
Scan Table alone: <100 microamperes.
H.5.2 Scan Table
The following are the power specifications for the DPX product line. Check the power
specifications label on your scanner to determine which power specifications apply to
your scanner.
Bertan/Spellman 100 Range: 90-110 VAC 50/60 Hz 10A
P/N 0311 and 0312 115 Range: 103-127 VAC 50/60 Hz 10A
230/240 Range: 207-264 VAC 50/60 Hz 7.5A
H.6 X-ray Generator Specifications
H.6.1 X-ray Generator
Table H-1 contains information about the X-ray generator for DPX-IQ series devices.
Table H-1: X-ray generator technical information.
Classification Class I Equipment IEC 601-2-7 5.1
Degree of protection against electrical shock Type B equipment IEC 601-2-7 5.2
Protection against ingress of liquids Ordinary medical electrical equipment IEC 601-2-7 5.3
Connection to supply mains Detachable power cord IEC 601-2-7 6.1g)
Mode of operation Continuous IEC 601-2-7 6.1m)
Maximum X-ray tube voltage 76 Kv IEC 601-2-7 6.1m)
Maximum X-ray tube current 5 mA IEC 601-2-7 6.1m)
Rated mains voltage 100/115/230/240 volts IEC 601-2-7 6.1j)1
Number of phases in mains 1 IEC 601-2-7 6.1j)2