we brighten up your life
LUMZ PTE LTD
INSTALLATION MANUAL
LED MARINO
MARINO/INSTALLATION MANUAL/REV.2
2/2
Factory:
No.14, Jalan Anggerik Mokara 31/44, Kota Kemuning Seksyen 31,
40460 Shah Alam, Selangor, Malaysia.
Tel: (00603) 5121 1887
Fax: (00603) 5121 5187
Email: [email protected]
Singapore Office (HQ Sales & Marketing):
1 Coleman Street #10-06, The Adelphi,
179803, Singapore.
Tel: (0065) 9758 2771
Email: [email protected]
www.lumzlighting.com
Connect all wires from the luminaire to AC power using a connector.
Make sure all wiring connections are tight so that no bare wires are visible.Good connections may avoid tripping from happening.
For wiring, use a terminal complies with EN 60998-2-1 and EN 60998-2-2.
Consult your local authority regarding disposal or recycling procedures of removed ballast and lamps.
Read the Installation Manual instruction carefully before install the products to ensure that you obtain the best possible results.
NOTE:
INSTALLATION INSTRUCTION
Put the wave tube through the nut
and the rubber plug.
Fasten the nut with the screw by using
a tool.
Screw PPG13.5 with connector on the
wave tube tightly with two wrenches.
Fix the backcover to the outer sleeve
with screws provided.
Put the cable through the wave tube and
the hole of the outer sleeve from outside.
Then insert the cable into the nut/rubber plug
and the screw of the PG13.5.
Make sure the nut with screw of PG13.5 fix tightly.
# The wave tube should reach the bottom of the rubber plug
Prepare a minimum recess opening for the installation for
each of the outer sleeve.
Refer to Recess Opening Dimension for specific models.
Connect the luminaire with
power cable using connector.
Make sure the connector is fasten tightly.
Fix outer sleeve into the holes.
Fasten with screws provided
on the wall of the pool with screwdriver.
# The distance between the recess opening and ground should less than 1 meter
# Make sure power is disconnected before installation
1
2
3
4
5
6
<1m
HOLE
Fix two “L” bracket on the outer sleeve.
Fix the luminaire into outer sleeve
by using screwdriver with screws provided.
Make sure all screws fix tightly.
Fill in water into the pool
after installation.
SCREWDRIVER
POOL
CONNECTOR
MINIMUM
RECESS OPENING
“L” BRACKET
WAVE TUBE
OUTER SLEEVE
OUTER SLEEVE
SCREWDRIVER
RECESS
OPENING
OUTER
SLEEVE
