www.Lumishore.com
NOTE : When in standby mode power to the system will still be active until power is disconnected using a master switch
or circuit breaker. See installation guide for the correct way to install the system.
SUNCOVER:
A Suncover is provided to protect the controller from harmful UV rays from the Sun and general weathering and also
protects the device from accidental operation. Always ensure the Suncover is in place when the controller is not in use.
3.0
Initial Light Set Up
The Initial Light Setup tells the controller what position the lights are installed on the vessel so that they can be sent
information in the correct order and color change in the correct sequence.
Setting up the lights with their correct position ensures modes such as “Color Sweep” function correctly
.
Set up is very straightforward and will only take a short amount of time. Once setup is complete the system will memorise
the light positions so this process only needs to be carried out once.
To set up the lights use the following steps and the example positions shown below. The diagram shows typical positions of
installed lights for three scenarios.
NOTE: In each installation, Position number 1 should be the furthest light forward on the
Starboard side. At each stage note the number of each light in accordance with these schematics.
Example Positions for 5 lights
Example Positions Transom Only
Position 1
Position 2
Position 3
Position 4
Position 5
Position 1
Position 2
Position 3
