Safety Information
1.
3
.
5.
6,
Do not place abjects in the path of the blades.
7,
To avoid persona! injury or damage to the fan or
other items,use caution when working around or clean i ng the
fan.
8,
Electrical diagrams are for reference only. Light kits that
are not packed with the fan must be UL-listed and marked suitable for use
with the model fan you are installing. Switches must be UL General
Use Switches. Refer to the instructions packaged with the light kits and
switches for proper assembly.
9,
After making electrical connections, spliced conductors
should be turned upward and pushed carefully up into tne outlet box.
The wires should be spread a part with the grounded conductor and
the equipment-grounding conductor on one side of the outlet box.
10,
Ali set screws must be checked and re-tightened where
necessary before installation.
2
WARNING:TO
reduce the risk of persona! injury,
do not bend the blade brackets (also referred to as
flanges) during assembly or after installation.Do not
in sert abjects in the path of the blades .
WARNING:
Remove the rubber motor stops on
the bottom of the fan before installing the blades
or testing the motor.
WARNING:
To redu ce the risk or fire or electric
shock,do not use this fan with any solid-state
speed contrai device.
WARNING:To
avoid possible electrical shock,
turn the electricity off at the main fuse box before
wiring.It you feel you do not have enough electrical
wiring knowledge or experience, contact a licensed
electrician.
WARNING:
Electrical diagrams are for reference
only. Optional use of any light kit shall be UL-listed
and marked suitable for use with this fan.
WARNING:
To redu ce the risk of fire, electric shock,
or persona! injury. mou nt to outlet box marked"
Acceptable for fan support of 35 ibs.(15.9 kg)or
less." and use the screws provided with the outlet
box.
To reduce the risk of electrical shcok, make sure the electricity
has been turned off at the circuit breaker or fuse box before
beginning.
2.
All wiring must be in accordance with the NAtional Electrical
Code NAS
I/
NF
P
A 70-1999 and local electrical codes. Electrical
installationsshould be performed by a qualified licensed
electrician
The outlet box and support structure must be securely mounted
and capable of supporting 35lbs. (15.9kg). Use only UL listed
outlet boxes marked
¨
acceptable for fan support of 35lbs
¨.
4.
The fan must be mounted with a minimum of 7Ft (2m) clearance
from the trailing edge of the blades to the floor.
Do not operate the reversing switch while the fan is in motion.
Yo
u
must turn the fan off and wait till the blades come to a complete stop
before you reverse the blade direction.
