REV. 02/26/2020 PN:
PG:2
2257 route 139
Drummondville, Québec
J2A 2G2
WWW.INNOVAPLAS.COM
1 year on step and ladder.
1 year on hardware.
MANUFACTURER WARRANTY
AQUARIUS 5010 WITH CLASSIC LADDER 6003
D
B
E
C
D
1)
Snap the three post ends into the
step, making sure that the cylindrical
part is vertical and that the ends are
snapped properly in their respective
housings.
2)
Snap the filler post end into the step
as shown.
3)
Snap the two feet to the bottom of
the step.
FILLER
1)
Fill the bag provided with sand.
The approximate weight should
be 5 lbs.
*SAND
1)
Slide the two tie
wraps in place and
place the sand bags
into the riser.
2)
Fasten the tie wraps.
Do not overtighten.
4x
4x
*Sand not included
35” post
F
1) 1)
Insert the two large posts and
the 35” post into the post ends and
secure them in place with the screws
provided
(as shown on the right).
2)
Insert the platform over the rear post.
3)
Insert the small and large
handrails as illustrated. Secure the
large handrail with the screws
provided. Leave the small handrails
floating.
4)
Fasten the access panel with the
screws provided (as shown on the right).
x17
D
x3
D
x2
3
1
/
4
”
1/4”
align screws from
center of plate
E
point 4
point 1
1)
Insert the two step cups in the riser.*
2)
Place the riser on the ground, install the step
on top of the riser and fasten with the four
screws and plastic screw caps provided.
3)
Snap the screw caps covers in place.
* View step cups installation tips on YouTube:
https://www.youtube.com/watch?v=W5RH1VNxpu0
