20
7.3
Connecting the Sensors to the PCB Controller
Connect the sensors to the PCB Controller with a flat cable (FFC cable).
Sensor - PCB Controller wiring includes:
•
Sensor –FFC Cable Wiring below
•
PCB Controller – FFC Cable Wiring on page 22
7.3.1
Sensor –FFC Cable Wiring
Connect the sensor to the FFC (flat) cable according to the following procedure. Failure to comply may lead to
improper connectivity.
To connect the sensors to the FFC (Flat) cable:
1.
Open the roll of flat cables.
Figure 9 Flat Cables
2.
Slide open the connector latch situated at the rear of the sensor.
The connector opens.
3.
Insert the flat cable into the connector.
Note
: Ensure that the flat cable is:
o
Inserted into the connector as deeply as possible
o
Inserted straight
o
Inserted with the blue tape facing up
4.
Slide closed the connector latch.
The flat cable is locked into the sensor.
Figure 10 Sensor - Cable Connection
