Page 2 of 2
REV2.3
RSLW8 Channel -
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
7
Ensure power is off to power supply!
Also ensure the correct (wattage and voltage) power
supply is used to power LineLED. Then proceed to
connect LineLED wires from RSLW8 extrusion to power
supply. For more information please refer to power
supply and LineLED wiring instructions.
power to LineLED of
RSLW8
extrusion
class II
power
supply
line voltage wires
6
Wipe extrusion with a wet rag
and ensure it is completely dry
before installing LineLED. Gently
press LineLED strip/s onto aluminum
extrusion and then proceed to install
endcaps.
Note
- Maximum run per power
feed is determined by the type of
linear LED products selected. Please
consult the specifications of the
linear LEDs used.
low voltage wires
feed LineLED
wires through
opening in
endcap
remove paperbacking from adhesive tape of the
LineLED before installing onto the extrusion
longer runs of
RSLW8
can be created by
locating multiple
aluminum extrusions
end to end
endcap
endcap
Size polycarbonate diffuser lens by cutting to appropriate
length to fit aluminum extrusion. Install lens by snapping into
aluminum extrusion.
diffuser
lens
wires to
power
supply
8
