*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Page 1 of 2
Please read all instructions prior to installation and keep for future reference!
This power supply is to be installed in accordance with Article 450 of the National Electrical Code. The power supply must be
installed in a well ventilated area and free from explosive gases and vapors. Proper operation requires the free flow of air. As
this power supply is hardwired, it should only be installed by a qualified electrician. UL class 2 recognized
2
2.1
Remove the two Phillips screws from the top of the driver housing
and pull the cover off to expose the driver wires.
driver housing
cover
2.1
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
MODELS
A
.
Length
C
.
Depth
PDCU-30-24
6.50”
3.73”
1.61”
A
B
.
Width
B
C
1
1.1
Power supply can be mounted vertically or horizontally. With a
minimum of 2" clearance around power supply to provide proper
air circulation.
Before installing, check the label and ensure the power
supply has the proper input voltage, output voltage, and
wattage for the job. Check the wire markings to ensure
they match the wiring diagram below. Refer to table
above for the maximum loads!
2” min.
2” min.
2” min.
REV0.0 12032019
PDCU-60-24
PDCU-96-24
PDCU-3x96-24
7.40”
8.66”
11.85”
3.73”
3.73”
4.32”
1.61”
1.61”
1.81”
Net Weight
2.0 lbs
2.4 lbs
2.8 lbs
5.2 lbs
screw
3
3.1
Insert the 120-277 VAC power into the driver housing from the
electrical panel. Followed by bringing the 24V DC low voltage
wires from the LEDs into the driver housing. In addition bring the
controller wire if applicable. Refer to diagram on page 2 to make
all the proper wiring connections.
driver
housing
24VDC
conduit
3.1
120-277 VAC
conduit
Controller
MAX Load
30 watts
60 watts
96 watts
3x 96 watts
Models PDCU-30-24, PDCU-60-24, PDCU-96-24, & PDCU-3x96-24
PDCU Pure DC
Universal Power Supply -
Installation Instructions
®
