Page 2 of 2
PLAS Channel -
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
3. If extrusion is installed facing up and in a wet location, ensure proper drainage and silicone
endcaps and diffuser lens.
REV0.0 10072019
*OPTIC ARTS BY LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
T 224.333.6033
www.opticarts.com
protective
film
power to LineLED
of PLAS extrusion
Class 2
power
supply
line voltage wires
low voltage wires
6
Use
No.4
1/2” long fasteners
to mount extrusion through drilled
mounting holes. Once extrusion is
in place, snap-on diffuser lens and
finally remove its protective film.
diffuser
lens
7
Ensure power is off to power supply! Then proceed to connect
LineLED wires from PLAS extrusion to power supply. Refer to
power supply and LineLED wiring instructions.
