Page 2
For technical questions, please call 1-888-866-5797.
Item 58225
Specifications
Bulb Type
12 pcs SMD LEDs
Battery Type Lithium-Ion 3.7V
1500mAh, 18650
Run Time
/ Lumens
Candle Mode: 27 hrs / 4 lm.
Low Mode: 27 hrs / 8 lm.
High Mode: 23 hrs / 16 lm.
Important Safety Information
1.
THIS IS NOT A TOY; FOR
DECORATION ONLY.
2.
DO NOT APPLY PRESSURE TO
GLASS LENS WHEN INSTALLING.
3.
ENSURE SOLAR LIGHT IS
SECURELY STAKED INTO THE
GROUND PRIOR TO USE; FOR
INDOOR OR OUTDOOR USE.
4.
LENS IS MADE OF GLASS AND
CAN BREAK, USE CAUTION,
WATCH FOR SHARP PIECES.
5. Assemble only according to these
instructions. Improper assembly
can create hazards.
6. Wear ANSI-approved
safety goggles during setup.
7. Keep assembly area clean and well lit.
8. Keep bystanders out of the
area during assembly.
9. Do not assemble when tired
or when under the influence
of drugs or medication.
10. Position battery in proper polarity.
11. This product is not a toy. Do not allow
children to play with or near this item.
12. Use as intended only.
13. Inspect before every use; do not
use if parts are loose or damaged,
or if sharp edges are exposed.
This is fragile and sharp edges may be
exposed if weathered or damaged.
14. Maintain product labels and nameplates.
These carry important safety
information. If unreadable or missing,
contact Harbor Freight Tools
for a replacement.
15. Contains Li-Ion battery. Battery
must be recycled or disposed of
properly. Do not open, crush, heat
above 140° F or incinerate.
Setup Instructions
1. Decide where you want to place
the Solar Light, indoor or outdoor.
Choose a location that receives full,
direct sunlight a minimum of 8 hours
a day. The location should not be
near nighttime light sources such as
porch lights or streetlights as this will
cause the Solar Light to remain off.
2. Confirm that the location is clear
of lines, cables and conduits.
3. With a rubber mallet (not included),
gently tap the Stake into the ground.
4. Attach Stake to connector and connect
remaining pieces using plugs. Adjust
height using one or two plugs. Attach
lantern to base and connect to pole.
5. Allow at least 24 hours charge
time before first use.
