16
ETL Model No.: CF955L
7. Remote Control Procedures
7.1: Preset Memory Feature
Your Receiver is equipped with a preset memory
feature. If the AC supply to the Receiver is powered
through a Wall Switch, when the Switch is turned OFF,
the Control will remember the Light Intensity and Fan
Speed.
When the Switch is turned back ON the Light and Fan
will resume operation as they were prior to the Switch
being turned OFF.
7.3: Setting Operating
Frequency of Remote Control
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Control (Figure 28).
Your Remote Control has Code Switches which must
be set in one of 32 possible code combinations.
The Five Levers (numbered 1, 2, 3, 4, and 5) on
the Switches are factory-set in the ON (up) position.
Change the Switch settings as follows:
Slide the Five Switch Levers in the Remote Control to
your choice of ON (up) or down positions. Use a ball-
point pen or small screwdriver and slide the Levers
firmly up or down.
The Sixth Switch marked ON and I is for dimming
control of lights: Set Switch to ON to allow for dimming
of the lights. Set Switch to I for no dimming of the lights.
NOTE: If your fan and light go on and off without
using your control, you may be getting interference
from other remote units such as garage door
openers, car alarms or security systems.
To remedy this situations, simply change
the Combination Code in your Remote Control
Transmitter.
CODE
SWITCHES
REMOTE CONTROL
BATTERY
COMPARTMENT
COVER
REMOTE CONTROL
LEVERS
ON
1 2 3 4 5
I
Figure 28
7.2: Installation of Batteries
The Remote Control Transmitter is powered by Two
AAA Alkaline Batteries.
To prevent possible Battery leakage damage, be sure
to remove the Batteries when the Control is not to be
used for an extended period of time.
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Remote Control.
Install Two New AAA Alkaline Batteries into the Battery
Compartment following the correct Battery placement
printed on the Compartment (Figure 27).
Replace the Battery Compartment Cover by sliding the
Cover back onto the Remote Control.
REMOTE CONTROL
BATTERY
COMPARTMENT
COVER
TWO AAA
BATTERIES
Figure 27
Fan installation must be completed, including the
installation of the fan blades, before testing the remote
control.
WARNING
!
NOTE: Never use old and new batteries together in
unit.
Summary of Contents for kathy ireland HOME MIDWAY ECO LED CF955LBS00
Page 78: ...78 Mod le ETL N CF955L Notes...
