LADDER FOR
ROYAL ENTRANCE OR WEDDING CAKE STEP
Installation
www.lumi-o.com
Read carefully the cautions and every steps before assembly and using your step.
Caution : File off all stripped or sharp edges before assembly to avoid injuries and pool damage.
Rev. 2007-11-27
p.1
1 -
Attach the platform to the
left and right ramps using four 2”
bolts, washers and nuts (fig. 1).
2 -
Peel the protective backs
off the self-adhesive pads and center
the pads on the polished areas on
the back of the step (fig. 2).
3 -
Insert the rails into the step
(short rails on top) and align with the
predrilled holes. Attach sing the eight
2½” (8), bolts, washers and nuts
(fig. 3).
4 -
Slide the ramps over the
short rails and leave unatached.
Insert the diagonal rails onto the long
and short rails. From the outside of
the step, attach using four 10X¾” (4)
self tapping screws (fig. 4).
5 -
Move the step into the water
and leave unattached.
6 -
Pour sand* (approx. 50 lbs.)
into the fence until it is ¾ full (fig. 5).
7 -
Slide the fence into the step
and push it towards the foot of the
step (fig. 6).
8 -
Move the step back against
the pool wall and level it horizontally
(fig. 7).
9 -
Adjust the platform until it
rests on the toprail. Once at the right
level, attach using the eight 10X¾” (8)
self tapping screws (fig. 8).
Fill
Line
Cap
Left Ramp
Platform
Right
Ramp
Short Rails
Long Rails
Diagonal
Rails
Sand
Fig. 1
Fig. 3
Fig. 5
Fig. 7
Fig. 2
Fig. 4
Fig. 6
Fig. 8
