5. Secure the upper cover of the end cap with 2 longer screws.
3. Insert the plug into the bottom part of the end cap.
Note: position before installing screws
4. Install the upper cover of the end cap.
9. If not already installed, push the PVC clips inside
the 1450 profile (we recommend using 1 PVC
clip every 6” for better results).
10. Align the LED strip with the 1450 profile
and clip it into place.
11. Slide the lens into place.
12. Screw on end caps.
7. Push the silicone gasket into the stub. Insert the end of the
strip into the stub completely.
MAKE SURE THAT THE PRODUCT IS DISCONNECTED FROM ANY POWER SOURCE BEFORE AND THROUGHOUT CUSTOMIZATION AND INSTALLATION PROCESS.
Warning: Risk of electric shock
6. Secure plug assembly to LED tape.
Note: position before installing screws
8. Insert the stub into the bottom part of the end cap.
Repeat steps 4 through 6.
8a
8b
