Full product range & more information:
www.lumenalights.com
INSTRUCTIONS
Ultra-Spike Light
–
12v
All finishes
WARNINGS
PLEASE READ THESE INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION / MAINTENANCE
•
If a fitting is found to be damaged, cease use immediately.
•
This is a Class 3 product (Low Voltage)
–
no earth required.
•
12V TRANSFORMER REQUIRED
–
sold separately
•
This unit must be fitted by a competent person
–
if in doubt consult a qualified electrician.
•
Install in accordance with IEE wiring regulations and current Building Regulations.
•
To prevent electrocution, switch off mains supply before installing or maintaining this fitting. Ensure other persons cannot restore
the electrical supply without your knowledge.
•
This light fitting should be connected to a circuit with a 30Ma RCD fitted.
•
If replacing an existing fitting, make a careful note of the connections.
•
When changing the bulb(s), always switch off at the mains & allow the bulb to cool before handling
–
LAMP WILL GET HOT
WHEN IN USE
.
•
All connections should be made as watertight as possible to avoid electrical shortage.
•
Always use the correct type & wattage of bulb. Never exceed the wattage stated.
•
The unit may get warm whilst on for a period of time.
•
12v Lighting must be wired in parallel, not series, and cable lengths kept to a minimum.
•
DO NOT INSTALL INTO THE GROUND BY PUSHING THE HEAD OF THE
PRODUCT
SILICA GEL & O-RINGS (DO NOT REMOVE):
A small pack of silica gel has been included with this spike light, located inside the head with the bulb holder. This should
not
be
removed. Condensation inside the spike light is inevitable due to the heat generated from lamps and cold weather conditions,
especially if installed on a damp day. The pack of silica gel will collect the moisture inside the fitting, preventing this. It is
recommended that the silica gel is replaced when the light bulb is replaced, if not before, and the white rubber o-ring checked.
This should be replaced if there are any signs of damage
–
a spare is provided with each fitting.
CLEANING:
Occasional cleaning and care is recommended for this product. Please refer to our website for the best way to clean different
materials.
RETURNS:
If purchased from a 3
rd
party, please contact your supplier. If purchased direct, contact us by phone or email:
Lumena Lights Ltd, Centre 33 Long March, Daventry, NN11 4NR Tel: +44 1327 871161 Email: [email protected]
Our full returns policy is available on our website.
Waste Electrical Products should not be disposed of with household waste. Please check with your local authority or contact us
for more information. Please recycle packaging whenever possible.
Producer Registration Number: WEE/KC3440XY
Voltage:
12v Low Voltage
Max. Wattage:
35w
Bulb Holder:
MR16 (lamp sold separately
–
LED recommended)
IP Rating:
IP65
Cable Length:
2 Core Rubber Cable 0.75mm (open end)
–
2m or 5m
Head:
Adjustable
NOTES
Will accommodate longer than average MR16 bulbs.
Shorter bulbs will not create the exact beam angle stated.
✔✔
2 YEAR
GUARANTEE
see website for
more details
LUMENA UNIQUE PRODUCT
REGISTERED DESIGN NO. 5002740
